Using Analysis Control for Power Integrety

I am runnig a power integrety analysis (Hyperlynx 9.4) from the Analysis Control window inside Expedition.   It shows a problem at the Power Module.  So far so Good.

In Expedition I made changes to improve the situation at the Power Module.

      Old Situation                                                             New situation

Now I run the Power Integrity simulation again, but it keeps using the old design data instead of the updated plane.  Terminating the client and starting it again does not help.

(You can see this when you open the Powerscope. It keeps showing the old info)

Any idea's