I have a couple of questions as I'm a little new to the xPCB family, but a long time PADS user.
When I’m routing a trace, I often hit the edge of the screen. Is there a to zoom into the cursor location
and/or to make it centered on the screen while routing? I've tried ZC (needs cooridinae) and zooming in/out, but it leaves cursor at the edge of the screen.
Also is there a way to change a via after it’s placed other than by its properties? I could see a very useful feature update where
one could change an existing VIA by highlighting the via and doing RMB which would have a pull down menu of available via options. Currently I think you can only do this by going through the properties menu.
Best,
-Jeffrey